TelosB¶
Support for the TelosB board.
MCU¶
| MCU | TI MSP430F1611 |
|---|---|
| Family | MSP430 |
| Vendor | Texas Instruments |
| Package | 64 QFN |
| RAM | 10Kb |
| Flash | 48Kb |
| Frequency | 8MHz |
| FPU | no |
| Timers | 2 (2x 16bit) |
| ADCs | 1x 8 channel 12-bit |
| UARTs | 2 |
| SPIs | 2 |
| I2Cs | 1 |
| Vcc | 2.0V - 3.6V |
| Datasheet / Reference Manual | Datasheet |
| User Guide | User Guide |
Radio¶
| RF Chip | Texas Instruments® CC2420 |
|---|---|
| Frequency Band | 2.4GHz ~ 2.485GHz |
| Standard compliance | IEEE 802.15.4 compliant |
| Receive Sensitivity | -95dBm typ |
| Transfer Rate | 250Kbps |
| RF Power | -25dBm ~ 0dBm |
| Range | ~120m(outdoor), 20~30m(indoor) |
| Current Draw | RX: 18.8mA TX: 17.4mA Sleep mode: 1uA |
| RF Power Supply | 2.1V ~ 3.6V |
| Antenna | Dipole Antenna / PCB Antenna |
| Datasheet | Datasheet |
Flashing RIOT¶
Flashing RIOT on the TelosB is quite straight forward, just connect your board using the USB connector to your host computer and type:
make flash
This should take care of everything!
Using the shell¶
The shell is using the UART interface of the TelosB at 115200 baud.